Please email can also check out the Processing Documentation and Support page for a wide range of information including help with reflow solder, wave soldering, solder locks, cleaning, and more. Have a question about a Samtec product, and which class it would meet in IPC-A-610? We are here to help answer that question. Here at Samtec we are always focused on ways to be a service leader in this industry, and assisting customers with processing questions is no different. Usually there is room, workstation and task lighting, A simple downloadable phone app will work as will a calibrated light meter when required. If you made it this far, then clearly you are interested in the topic, and want some additional information. The IPC-A-610 guidelines call for 1000 lm/m2 (approximately 93 foot candles).
While this may not seem to be a huge increase, it does add to the difficulty of producing a conforming product.
The side overhang is lowered to a 25% maximum of the width of the lead (4), and end joint thickness (3) is increased to a minimum of 75% of the lead width (4).
#IPC 610 MANUAL MANUAL#
H., Manual (Tax Exempt) 250.00 Add to cart. The bibliometric network of F igure 2 indicates that there are three clusters. The solder thickness (5) requirement remains “not specified,” and the side joint length (6) are the same as Class 2, but many of the other specifications have increased requirements.įor instance the side overhang (2) and end joint width (3), are tightened in both directions by 25%. H., Certification (Tax Exempt) 1,690.00 Add to cart Protected: IPC-A-610 Rev. Figure 2: Solder and Manual Inspection according to IPC-A-610. Mil / Aero and Medical applications typically require Class 3 products.Ĭlass 3 increases the requirements in most areas of inspection for the solder joint over Class 2. Manual, IPC-A-610 (current revision), AJ-820A and a CD-ROM which includes certification and recertification visual presentations and IPC-A-610 Instructor Guide for training Certified IPC Specialists. The IPC-610F is a PC/AT-compatible computer designed for industrial applications. Flexible and Rigid-Flex IPC-6202 IPC/JPCA Performance Guide Manual for. Many of Samtec’s products can meet IPC-A-610 Class 3 which is normally required when a product must have continued high performance in extreme / harsh conditions. IPC-3408 General Requirements for Anisotropically Conductive Adhesives Films. The side joint length (6) of the solder joint, at the narrowest point, must be at least 150% the width of the lead (4). The solder thickness (5) between the lead and the pad landing is not specified, but a properly wetted fillet must be present.